Install Dash-Cams on rear doors of my #NissanLEAF

Click a Photo to expand its Size and read the file name.
Thursday, July 09, 2015, at 08:22:55

01.  Here is the plastic trim around the window of the back door - The Wire Will Not fit inside this frame, it is too thick---- 02.  The Camera has Adhesive but that will fall off over time and so I drille two holes and used these tiny screws from the inside out on an extreme angle--- 03. I may need to use some clips, wire ties or glue to hold the wires down and snug around the outside edge of the window frame--- 04. This is the flexible connection between the rear doors and body of the car, I pulled it off at both sides and stuck a piece of a hanger through it---- 05. be careful not to puncture the flexible connection, take your time---- 06. Duct tape and the hanger taped to the wire that comes from the camera---
01. Here is the plastic trim around the window of the back door - The Wire Will Not fit inside this frame, it is too thick---- 02. The Camera has Adhesive but that will fall off over time and so I drille two holes and used these tiny screws from the inside out on an extreme angle--- 03. I may need to use some clips, wire ties or glue to hold the wires down and snug around the outside edge of the window frame--- 04. This is the flexible connection between the rear doors and body of the car, I pulled it off at both sides and stuck a piece of a hanger through it---- 05. be careful not to puncture the flexible connection, take your time---- 06. Duct tape and the hanger taped to the wire that comes from the camera---
07. Not shown here but I ran the cable from the camera straight down from where I mounted it to along the outside skin of the door and wrapped around this bottom cross beam--- 08. Also not shown here the USB cable from the dashcam was zipped tied to the bottom crossbeam-pipe and then fed right through the hole in the door behind this flexible connection--- 09. You must keep the wire away from the window mechinism--- 10. Wire has been run and I put this flexible connection back togather---- 11.  Wire pulled to bottom of column between the two doors and below the seatbelt mechinism--- 12.  I used an Electrical Snake to pull the USb cable from the bottom of the middle column and under the carpet to the middle hump---
07. Not shown here but I ran the cable from the camera straight down from where I mounted it to along the outside skin of the door and wrapped around this bottom cross beam--- 08. Also not shown here the USB cable from the dashcam was zipped tied to the bottom crossbeam-pipe and then fed right through the hole in the door behind this flexible connection--- 09. You must keep the wire away from the window mechinism--- 10. Wire has been run and I put this flexible connection back togather---- 11. Wire pulled to bottom of column between the two doors and below the seatbelt mechinism--- 12. I used an Electrical Snake to pull the USb cable from the bottom of the middle column and under the carpet to the middle hump---
13. Both wires from both Cams met in the void on top of the center hump, from there I used the snake to pull the wires under the armrest and center console and then into my glovebox---
13. Both wires from both Cams met in the void on top of the center hump, from there I used the snake to pull the wires under the armrest and center console and then into my glovebox---